Side Protocol
DiscordTwitter
  • overview
    • Side Introduction
      • Preliminary
      • Architecture
        • Bitcoin Compatibility Layer
        • Oracle++
        • Trustless Relayer
        • Native BTC-Collateralized Lending System
          • Lending Workflow Overview
          • Loan Assignment
          • Repayment
          • Liquidation
          • Loss of Liveness
        • Additional Features
        • Interoperability
      • Security
    • Front-end
      • Side Station
      • Side Hub
      • Side Wallet
      • Product FAQs
        • How to bridge sBTC
        • How to bridge Runes
        • How to bridge USDC
        • How to switch gas token
        • How to switch wallet address type
    • $SIDE Token
      • Role of $SIDE
  • Developer
    • Mainnet
      • Side Chain Node Installation & Setup
      • Run a Full Node
      • Run a Validator
      • Cosmovisor
      • State Sync
    • RPC
  • About
    • Official Links
    • General FAQs
    • Privacy Policy
Powered by GitBook
On this page
  • OKX Wallet (Highly Recommended):
  • Unisat Wallet (Highly Recommended):
  • Xverse Wallet (Medium Recommended):
  1. overview
  2. Front-end
  3. Product FAQs

How to switch wallet address type

PreviousHow to switch gas tokenNext$SIDE Token

Last updated 3 months ago

Your BTC balance consists of Bitcoin stored in different types of addresses within your Bitcoin wallet (Taproot, Legacy, Nested SegWit, Native SegWit).

Side Chain (the Side Protocol blockchain) is a fully Bitcoin-compatible chain that supports Taproot and Native SegWit address types. You can transact on Side Chain directly using your Bitcoin mainnet address.

Follow the instructions below to learn how to switch address types using extension wallets.

OKX Wallet (Highly Recommended):

  1. Select your BTC asset

  2. Click “Set Default Address”

  3. Choose the address type (Taproot or Native SegWit) that holds the balance you wish to use. Your BTC balance will update as you switch between address types.

  4. Once selected, reconnect your wallet on Side’s UI to update your address type.

Unisat Wallet (Highly Recommended):

  1. Go to "Settings" and click "Address Type"

  2. Choose the address type (Taproot or Native SegWit) that holds the balance you wish to use. Your BTC balance will update as you switch between address types.

  3. Once selected, reconnect your wallet on Side’s UI to update your address type.

Xverse Wallet (Medium Recommended):

  1. Select your BTC asset.

  2. In the top-right corner, click the icon and select Native SegWit as the default address type.

  3. Note: Xverse Wallet only supports Native SegWit, while Side Chain supports both Native SegWit and Taproot. However, if you want to transfer native USDC between Side Chain and Noble, Xverse Wallet cannot be used.

Switch wallet type on OKX Wallet